I ll bet that you never knew you could adjust a self closing door hing.
Self adjusting door hinges.
If the self closing door to your garage isn t closing hard enough to latch properly or the door slams shut you can adjust the spring hinge tension with a hex wrench and pliers.
If there s a large gap between the door and the.
Unscrew the bottom door hinge on your door.
Use a screwdriver to unscrew each screw on the door hinge.
Cut 1 4 inch wide wedges from.
Remove the locking pin.
Wedge the stop under the door as.
Set up a power or cordless drill with a screw tip attachment.
Start by removing the locking pin photo 1.
Check the gap between the unhinged side of your door and the frame.
Then add or release tension until you get the proper close rate photo 2.
Tighten the screws where each hinge attaches to the.
However if your door slams or doesn t latch properly as it closes you may need to use a couple of tools to loosen or tighten the spring tension.
Get free shipping on qualified self closing door hinges or buy online pick up in store today in the hardware department.
Install a doorstop under the outer edge.
Open the door to a 90 degree angle.
How to adjust entry door hinges 1.