If successful the deadbolt will extend and retract.
Schlage connect door lock wont connect to wink hub.
Connect it to your smarthome hub.
I talked to wink and went through troubleshooting to no luck.
The lock will blink an orange light for a few seconds then you will get a green check mark on the lock as well as a green flash of light on your wink hub wink hub 2.
Schlage lock won t connect to hubitat or wink.
This allows you to communicate with your lock via the wink app when you are remote.
List of products included in this video.
In the new app click your hub from your dashboard.
I have reset the locks the hub is within a foot when i try to pair i have a zwave device 3 feet away that is paired new batteries in the locks uninstalled and reinstalled the new st app tried with new and old st app excluded get notification on app it worked and lock shows green check included lock.
The keypad should light up.
The wink app will also indicate that it has found the lock.
Then run the pairing command on your lock.
I tried several more times and no luck.
When used with your z wave compatible smart home automation hub alexa connects to your schlage connect smart deadbolt so you can lock your door and check whether or not you locked up before you went to bed by just asking.
In the top right hand corner there s 3 dots click that and choose z wave exclusion.
The lock should now be ready to go for manual usage.
To sync your schlage connect smart deadbolt with z wave plus to your wink hub open the wink app on your mobile device and follow the app s instructions.
They suggested contacting schlage which is a joke.
My app only shows one lock.
From there enter in one of the user codes.
Because the schlage connect is powered by z wave you need to pair it with a smart home hub like wink to extend communication with your home s wi fi.
Use amazon alexa to control your lock with your voice.
I went and replaced the lock thinking something went wrong with it but after installing a new lock it still wont connect.
I ran a exclusion and it did pick up the lock and removed the unknown device.
And you may be able to completely unpair your lock which allows the lock to be paired again with your hub.
Make sure the wink hub wink hub 2 is blinking a blue light then press the 0 button on your lock.
Bmott0817 april 24 2020 8 17pm 1.
They have yet to suggest anything to try.
Congratulations you are connected to your schlage touchscreen deadbolt.
I cannot set up the house lock and hub.
I tried moving my schlage lock from my wink hub over to my hubitat.
When you have successfully connected your devices you will see a flashing green check mark on the lock.
Get instant notifications whenever the door is unlocked.
